DAD LINK Keystone Jack Holder Din Rail Type

The DAD LINK Keystone Jack Holder Din Rail Type (KSJHDR) is a DIN rail mounted carrier that holds snap-in keystone modules inside an electrical enclosure, so an RJ45 termination can sit on the same rail as the breakers, terminal blocks and power supplies already in the panel. DAD LINK brands and supplies it in Iraq through authorized distributors.

It answers the case where a data drop has to land somewhere that is neither a wall plate nor a 19 inch cabinet. Typical deployments are a machine or PLC control panel on a factory floor, an ISP street cabinet where the fiber node and the copper handoff share one enclosure, a CCTV pole cabinet feeding cameras over PoE, and the small metal distribution panel a new-build office in Erbil fits instead of a full rack.

Specification

• Part number: KSJHDR
• Mounting: DIN rail, the same rail system used for breakers and terminal blocks in electrical enclosures
• Module format: standard snap-in keystone opening, so it accepts keystone jacks from the DAD LINK range
• Supplied as: holder only. Keystone jacks are ordered separately

How to choose

Choose the housing by where the cable ends, then choose the jack independently. Inside an enclosure, use this DIN rail holder. At a desk or a wall, use the 1 port faceplate or the 2 port faceplate. In a rack, use a 24 port unloaded patch panel. All three housings take the same keystone format, which is why the Cat.6 or Cat.6A and UTP or FTP decision is made on the keystone jack and not on the holder.

Terminate to T568A or T568B and keep the same scheme across the whole installation.

For availability across Erbil, Baghdad, Sulaymaniyah and Duhok, contact an authorized distributor.